Dynaspine Assembly Instructions

With the lip of the main
back unit facing towards
the back, position the
2 x back support plates to
the front of the main back
unit with the narrow ends
facing upwards, and the left
and right plates positioned
on either side to follow
the curve of the body..

Lie the product front side
down and pass the
2 x screws through
the slots in the main
back unit and secure
in the threaded holes
in the centre of the
sprung brackets, and
loosely tighten.

Select the desired height
of the back support
plates. This is determined
by the height of the
individual and the seat
in which Dynaspine is
being placed. Tighten
screws once the height
has been selected.

Stretch over fabric
covers onto both back
support plates.

Fitting Dynaspine to your chair

Chair/car seat with headrest

Dynaspine is fully portable
and can be easily fitted
to a variety of chair types
including those with or
without headrests and also
to vehicle seats.
Dynaspine is fastened by a
long continuous strap which
is formed into an upper and
lower loop, the lower loop
is completed by a two piece
snap buckle fastening.

Place Dynaspine against the
seat back with the lower lip
positioned between the back
and seat sections.

Pass the top strap loop over
the headrest of the chair.
Unclip the buckle on the
bottom loop, cross the two
ends over each other and pass
around to the rear of the chair.

Fasten the clip buckle
pulling both ends firmly.

Chair/car seat without headrest

Place Dynaspine against the
seat back with the lower lip
positioned between the back
and seat sections.

Pass the top strap loop over
the back of the chair.

Unclip the buckle on
the bottom loop, cross
the two ends over each
other and pass around to
the back of the chair.

Fasten the clip buckle
pulling both ends firmly.

Chair with separate seat and back section

Stand behind chair holding
Dynaspine with back
support plates facing
upwards and pointing
away from you. Pass the
top strap loop around the
backrest of the chair.

The loop should now secure
around the upright that
holds the back section
of the chair. Rotate the
Dynaspine so that the straps
cross over at the back.

Bring the Dynaspine over
the top of the chair so that
it sits correctly against the
chair back, you can slide
Dynaspine on the straps
to achieve a level position.
Unclip the buckle on the
bottom loop, cross the two
ends over each other and
pass around to the rear of
the chair.
Fasten the clip buckle
pulling both ends firmly.

Fasten the clip buckle
pulling both ends firmly.